Lift the grime and refill the joints with clean sand
Paver Cleaning and Joint Sand in Southside, FL
Ask for a free estimate to clean and re-sand Southside pavers by calling (904) 966-4279.
- Brings out deeper paver color
- Fresh joint sand helps lock pavers in place
- Gives weeds less room to grow
- Makes the surface easier to keep clean
- Free estimate, no obligation
Request a Free Estimate
Free, no obligation.
Can I get my pavers cleaned in Southside without a long wait?
A local contractor cleans pavers across Southside, FL, and you will hear back within 1 business day, usually much sooner. New joint sand is part of the job, and the free estimate comes with no pressure to book. To start, call (904) 966-4279.
Cleaning strips off the algae, pollen film, rust and dirt that dull pavers, so the surface looks brighter and grips better underfoot. New sand in the joints then steadies each paver and gives weeds less to hold on to. The back patio that went dark under the oaks can match the rest of the yard again. Walk the contractor to the worst spots when you book your free estimate.
Paver Sealing Southside Is Proud to Serve Northeast Florida
What is part of a paver cleaning job?
A cleaning job covers stain treatment, a light wash and new joint sand once everything dries. Book it alone, or treat it as the opening half of a sealing job. Shaded walks and sprinkler spots tend to eat the most time. (904) 966-4279 lines up a cleaning.
Stain treatment
A cleaner matched to the problem, whether algae, rust or tannin, goes on first and is tested on a small spot.
Light wash
A surface cleaner makes an even pass without blasting sand out of the joints.
Fresh joint sand
Clean, dry sand is brushed into each gap after the pavers dry, then settled with a few more passes.
Sealer if you want it
A coat of sealer can go on once the surface is completely dry. The sealing guide covers what that adds.
What are the signs my pavers need cleaning?
Signs include a green or black film along shady edges, a yellow dusting each spring, orange marks near sprinkler heads, weeds in the joints and sand on the driveway after rain. Green growth is the urgent one, since a slick walk or pool deck can cause a fall. Want a second opinion on yours? Call (904) 966-4279.
Is cleaning enough, or should I seal my pavers too?
A cleaning fixes how pavers look today, while a coat of sealer decides how long that look holds. Stopping at the wash costs less up front, but algae, rust and fading return on their own schedule. Sealing makes later washes easier, though it must be redone every few years. Say which way you lean when you book your free estimate.
How often should Southside pavers be cleaned?
Most homes do well with a wash about once a year, and Family Handyman names spring. Around Southside, washing after oak pollen season ends in May clears that film along with the winter grime. Shaded walks and sprinkler spots can need it sooner than a sunny driveway. Build a schedule for your yard by calling (904) 966-4279.
Does a harder blast clean pavers better?
No, extra force hurts pavers more than it helps. A Northeast Florida washing company says pressure makes rust stains worse, and Family Handyman warns that spraying into the joints knocks the sand out. A hard blast can also scar softer pavers. Ask which pressure and nozzle the contractor uses before you book your free estimate.
Technique counts as much as the machine. A surface cleaner held at an even height leaves a uniform finish, and a cleaner picked for each stain does the real work. Family Handyman also suggests a short test spray in a hidden corner. Have a question about the method? Call (904) 966-4279.
Why do oak leaves and pollen leave marks on my pavers?
A Northeast Florida washing company says live oaks drop tannin that stains concrete, and oak pollen covers surfaces from March to May. Wet leaves left in place leave darker marks. Summer afternoon storms then feed algae on top of that. A wash after pollen season clears most of it. (904) 966-4279 is the number for planning one around the trees on your lot.
What is the orange staining near my sprinklers?
Most often it is iron. A Northeast Florida washing company says iron in well water and reclaimed irrigation leaves orange stains on concrete, garage doors and stucco. A paver-safe rust remover lifts it, and the marks have to be gone before any sealer goes on. Point them out when you book your free estimate.
Why are white patches showing on newer pavers?
A chalky white film on a newer paver is usually efflorescence, which is natural salt working out of the concrete. Unilock says it typically fades in two to three months and can take up to a year, and sealing waits until it is gone. Old sealer that has clouded looks similar. Not sure which you have? Call (904) 966-4279.
Which paved areas can be cleaned at a Southside home?
Anything paved around the house can be cleaned, from the driveway and pool deck to the patio and front walk. Grime differs from one spot to the next, and so does the method. Pick the area that bothers you most, and book your free estimate.
Driveways
Tires, oil drips and long afternoons of sun land here first. Cleaning the driveway pays off most at the turning spots, where joints loosen first.
Pool decks and lanais
Pool pavers face splashing, chlorine and bare wet feet daily. Whatever Cleaning puts on a pool deck, the surface should keep its grip when wet.
Patios and courtyards
Patios under oak limbs stay damp and collect leaves, pollen and algae. Cleaning a patio mostly means getting the green and dark spots out.
Walkways and entries
Entry walks pick up mulch, soil and sprinkler spray. Cleaning the front walk is a small job, and it is the first thing a guest steps on.
What leaves Southside pavers dirty?
Oak tannin and pollen, storm sand loss, sprinkler rust, damp shade and worn sealer lead the list. A wash handles some of them, and sealing or repairs handle the rest. Which ones are on your property? Call (904) 966-4279 and find out.
1. Oak tannin and pollen
A Northeast Florida washing company says live oaks drop tannin that stains concrete and that oak pollen covers surfaces from March to May. Wet leaves left sitting make those marks darker.
2. Sand washing out
Summer storms wash sand out of the joints. Once the joints sit low, pavers start to shift and weeds take hold.
3. Orange sprinkler marks
Iron in well water and reclaimed irrigation leaves orange stains. Extra pressure only spreads them, so they call for a rust treatment first.
4. Green growth on damp sides
Humid subtropical air and afternoon storms feed algae, especially on shaded and north facing walks. Left alone, it turns slick.
5. Cloudy or worn sealer
A coat put down over dirt or damp pavers can turn milky or peel. Failed sealer has to be stripped, not coated over.
What does paver cleaning cost in Southside?
Cleaning alone is priced by the square foot, and the contractor sets the number after seeing the surface. Size, paver type and whether joint sand is needed all move it. The one published Northeast Florida range for the whole clean, sand and seal is $1.75 to $3.25 per square foot, so a wash by itself should land below that. For a price on your property, book your free estimate.
Planning to seal as well? Ask for one combined price, with the wash, the sand and the coat listed as separate lines. A Northeast Florida washing company says a failed coat has to be stripped first, and that costs more. If you want help comparing quotes, call (904) 966-4279.
Want a coat on top of the wash? Read about sealing your pavers, see the full list of towns, or go back to the Southside home page.
| Paved area | What it might be | Full clean, sand and seal |
|---|---|---|
| 400 sq ft | Patio and walkway | $700 to $1,300 |
| 800 sq ft | Standard driveway | $1,400 to $2,600 |
| 1,200 sq ft | Driveway and entry | $2,100 to $3,900 |
The last column multiplies each size by the $1.75 to $3.25 per square foot one Northeast Florida company published, read in November 2026. Cleaning alone is priced by the contractor and usually comes in lower. The quote for your home may differ.
Why use a local contractor for paver cleaning?
A contractor who works around Southside knows what oak shade, sprinkler iron and summer storms leave behind. Hold the quote up to the published rates on this page, and take as long as you like. To begin, book your free estimate.
A contractor who works nearby
A local company that covers Southside already knows the oak shade, the afternoon storms and the busy cross streets. The first visit goes faster and holds fewer surprises.
A free look, then a price
The visit and the estimate are free. If the number is not right for you, say no and move on.
Published rates to compare
Northeast Florida companies post what they charge per square foot, and this site shows the same range. A quote far above or below it deserves a question.
You set the pace
Take your time and get every line in writing. Read what to check before you hire first.
Want a free estimate to clean your Southside pavers?
Fill in the form or phone, and a contractor will answer inside 1 business day, usually much sooner.
Free, no obligation
What do cleaned pavers look like around Southside?
How does the paver cleaning process go, step by step?
Skip the sealer, and the visit ends after step four, when the joints are full. To set a date, call (904) 966-4279.
1. Measure and look it over
To price the cleaning job, the contractor takes measurements and writes down low spots, loose pavers, leftover sealer and places where water collects.
2. Cover and wash
Plants, screens and the garage door get protected, and the sprinklers go off. A surface cleaner washes the pavers with a light touch so the joint sand stays put.
3. Treat the stains
Rust, algae, tannin and white salt film each get a cleaner made for that stain, tried first on a small spot.
4. Refill the joints
Once the pavers are dry, joint sand is swept in, settled and topped off, and the extra is brushed clear.
5. Seal and walk the job
When sealer is part of the job, it goes on in thin passes by sprayer, roller or both. Afterward, the contractor walks the finished area with you and says how long feet and cars should stay off.
Frequently Asked Questions
Can I pressure wash brick pavers?
Yes, with a light touch. Family Handyman advises a test spray in a hidden corner, a second or two per paver and no spraying straight into the joints, which knocks the sand out. Fresh sand normally goes back in afterward.
How much is it to clean pavers?
Cleaning is priced by the square foot, and the contractor sets the number after seeing the surface. A full clean, sand and seal runs $1.75 to $3.25 per square foot at one Northeast Florida washing company. Ask for the wash and the joint sand as separate lines.
How much should I pay for paver sealing?
A fair quote around the First Coast sits inside $1.75 to $3.25 per square foot for the whole clean, sand and seal. A 600 square foot Southside driveway lands near $1,050 to $1,950. Find out what the price covers before you compare two numbers.
Do I need a license to pressure wash in Florida?
That depends on the work. Washing is not the same as installing or repairing pavers, so ask which license covers your job. The Duval County Tax Collector says anyone doing business in the county needs a Local Business Tax Receipt.
Should pavers be cleaned before they are sealed?
Yes. A Northeast Florida washing company says sealing over dirt or wet pavers is how jobs fail. The surface needs a wash, fresh sand and time to dry before any coat goes on.
How do I get oil stains off brick pavers?
Oil needs a cleaner made for it, not just water and pressure. A contractor tests a small spot first and may treat it more than once. Old stains that soaked deep can fade without vanishing, so ask what to expect.
Will cleaning remove orange sprinkler stains in Southside?
Usually yes, with the right treatment. A Northeast Florida washing company says iron in well water and reclaimed irrigation leaves orange stains, and more pressure makes them worse. A rust remover lifts them, then the surface is rinsed.
Why do my Southside pavers turn green under the oaks?
Shade, humidity and afternoon storms keep the surface damp, which algae needs. A Northeast Florida washing company says live oaks also drop tannin that stains concrete. Trimming limbs and aiming sprinklers away from the pavers helps.
Have grimy pavers in Southside that need a reset?
Call or fill in the short form, and expect an answer inside 1 business day, usually sooner.
Free, no obligation